News

　　Semi-enclosed hook group is one of the important components of lifting equipment. It can be divided into two forms: forged hooks and hook plates. When purchasing, consumers must choose qualified products and products that have been tested by all safety technologies. Safety is crucial when using them.

　　The hook group can be classified from different angles, including rings, rings, shackles, etc., with novel design, safe and reliable, and excellent quality. semi-enclosed hook group is widely used and has occupied a place in factories, mining, petroleum, chemical and other industries, and the prospects are very promising. Do you know what problems may arise when using the semi-enclosed hook group?

　　1. The phenomenon of inflexible rotation of the hook occurs

　　The reason for this is to consider whether the gap between the rotating parts is too small, and whether there are problems such as the double-sided plates not parallel to the holes of the beam shaft and pulley shaft, which leads to the hook being unable to deflect normally.

　　2. The hook cannot be classified continuously, and there are rings and rings

　　This situation is mostly caused by the absence of attention to the gap between the beam during the hook installation, resulting in a vertical deflection angle.

　　3. The hook cannot lift normally and other operations

　　In this case, it is necessary to check whether it is caused by bearing damage or wire rope stagnation. Otherwise, the bearing failure may be caused by the increase in rotational friction resistance.

　　In short, the above is an analysis of the possible causes of failures in the semi-enclosed hook group. Here, the editor also calls on everyone to do a good job in daily lubrication of lifting parts such as hooks to prevent the above-mentioned failures from occurring frequently and reduce production efficiency.

　　Semi-enclosed hook group is one of the important components of lifting equipment. It can be divided into two forms: forged hooks and hook plates. When purchasing, consumers must choose qualified products and products that have been tested by all safety technologies. Safety is crucial when using them.

　　The hook group can be classified from different angles, including rings, rings, shackles, etc., with novel design, safe and reliable, and excellent quality. semi-enclosed hook group is widely used and has occupied a place in factories, mining, petroleum, chemical and other industries, and the prospects are very promising. Do you know what problems may arise when using the semi-enclosed hook group?

　　1. The phenomenon of inflexible rotation of the hook occurs

　　The reason for this is to consider whether the gap between the rotating parts is too small, and whether there are problems such as the double-sided plates not parallel to the holes of the beam shaft and pulley shaft, which leads to the hook being unable to deflect normally.

　　2. The hook cannot be classified continuously, and there are rings and rings

　　This situation is mostly caused by the absence of attention to the gap between the beam during the hook installation, resulting in a vertical deflection angle.

　　3. The hook cannot lift normally and other operations

　　In this case, it is necessary to check whether it is caused by bearing damage or wire rope stagnation. Otherwise, the bearing failure may be caused by the increase in rotational friction resistance.

　　In short, the above is an analysis of the possible causes of failures in the semi-enclosed hook group. Here, the editor also calls on everyone to do a good job in daily lubrication of lifting parts such as hooks to prevent the above-mentioned failures from occurring frequently and reduce production efficiency.