News

Semi-enclosed hook set is one of the important components of lifting equipment. It can be divided into two forms: forged hook and hook plate. When purchasing, consumers must choose qualified products and products that have passed all safety technical tests. Safety is crucial when using them.

Hook groups can be classified from different angles, including rings, rings, shackles, etc., with novel designs, safety, reliability and excellent quality. Semi-closed hook sets are widely used and have occupied a place in factories, mines, petroleum, chemical and other industries, and the prospects are very promising. So does anyone know what problems may occur when using the semi-enclosed hook set?

1. The hook becomes inflexible in rotation

The reason for this situation is to consider whether the gap between the rotating parts is too small, and whether the double side plates are not parallel to the holes of the beam shaft and the pulley shaft, causing the hook to be unable to deflect normally.

2. Hooks cannot be rotated continuously and are classified into groups, including rings and rings

This situation is mostly caused by not paying attention to the gap between the beams during the installation of the hook, resulting in a vertical deflection.

3. The hook cannot be lifted normally

In this case, it is necessary to check whether it is caused by bearing damage or wire rope jamming. If not, the bearing may fail due to increased rotational frictional resistance.

In short, the above is the analysis of the possible causes of failure of the semi-closed hook group. Here, the editor also calls on everyone to do a good job in daily lubrication of lifting parts such as hooks to prevent the above failures from occurring frequently and reducing production efficiency.

Semi-enclosed hook set is one of the important components of lifting equipment. It can be divided into two forms: forged hook and hook plate. When purchasing, consumers must choose qualified products and products that have passed all safety technical tests. Safety is crucial when using them.

Hook groups can be classified from different angles, including rings, rings, shackles, etc., with novel designs, safety, reliability and excellent quality. Semi-closed hook sets are widely used and have occupied a place in factories, mines, petroleum, chemical and other industries, and the prospects are very promising. So does anyone know what problems may occur when using the semi-enclosed hook set?

1. The hook becomes inflexible in rotation

The reason for this situation is to consider whether the gap between the rotating parts is too small, and whether the double side plates are not parallel to the holes of the beam shaft and the pulley shaft, causing the hook to be unable to deflect normally.

2. Hooks cannot be rotated continuously and are classified into groups, including rings and rings

This situation is mostly caused by not paying attention to the gap between the beams during the installation of the hook, resulting in a vertical deflection.

3. The hook cannot be lifted normally

In this case, it is necessary to check whether it is caused by bearing damage or wire rope jamming. If not, the bearing may fail due to increased rotational frictional resistance.

In short, the above is the analysis of the possible causes of failure of the semi-closed hook group. Here, the editor also calls on everyone to do a good job in daily lubrication of lifting parts such as hooks to prevent the above failures from occurring frequently and reducing production efficiency.