News

　　Metallurgical spreaders are purchased by the lifting machinery safety management personnel, and then centrally apply. The sling must carry product quality certificates and instructions for use during the warehouse acceptance. The factory-made slings should at least have test-verified documents and documents, and should have design drawings and production requirements if necessary. All slings should be archived by the lifting machinery safety management personnel.

　　After they enter the warehouse, crane safety management personnel and equipment maintenance personnel should number the only identity of the metallurgical sling, and make a firm, wear-resistant, corrosion-resistant, and carry a permanent self-locking function; the sling should be marked with a number and a validity period for safety inspection; the sling should be hung on the sling, and should not be hung on the sling, and should not be damaged, especially small slings should pay attention to the safety of the personnel during use. The inspection validity period is 6 months. Slings that exceed the safety inspection validity period must be put into use after the repairman passes the re-inspection.

　　Before each use of metallurgical slings, the operator should check the content of the slings, conduct an overall inspection of the slings and the full length of the rigging, and prevent the use of slings in an unsafe state.

　　The above is an introduction to the basic requirements for the safe use of metallurgical spreaders. You can learn about it. If you have any questions and needs, you can consult and contact us at any time! You can also leave your contact information directly on the website, and we will contact you in time!

　　Metallurgical spreaders are purchased by the lifting machinery safety management personnel, and then centrally apply. The sling must carry product quality certificates and instructions for use during the warehouse acceptance. The factory-made slings should at least have test-verified documents and documents, and should have design drawings and production requirements if necessary. All slings should be archived by the lifting machinery safety management personnel.

　　After they enter the warehouse, crane safety management personnel and equipment maintenance personnel should number the only identity of the metallurgical sling, and make a firm, wear-resistant, corrosion-resistant, and carry a permanent self-locking function; the sling should be marked with a number and a validity period for safety inspection; the sling should be hung on the sling, and should not be hung on the sling, and should not be damaged, especially small slings should pay attention to the safety of the personnel during use. The inspection validity period is 6 months. Slings that exceed the safety inspection validity period must be put into use after the repairman passes the re-inspection.

　　Before each use of metallurgical slings, the operator should check the content of the slings, conduct an overall inspection of the slings and the full length of the rigging, and prevent the use of slings in an unsafe state.

　　The above is an introduction to the basic requirements for the safe use of metallurgical spreaders. You can learn about it. If you have any questions and needs, you can consult and contact us at any time! You can also leave your contact information directly on the website, and we will contact you in time!