What are the causes and prevention methods of semi-enclosed hook sets falling?
There are two reasons why the semi-enclosed hook group falls:
l. The whereabouts of the hook group
Cause analysis:
①The floating limit does not work, causing the hook head to rush to the top and cause the hook group to fall;
② Sudden start of excessive inertia force under heavy load;
③Seriously overloaded or seriously damaged the wire rope.
Methods and measures for exclusion:
Immediately repair the rising limiter to make the H base work sensitively. Follow the safe operating procedures and start smoothly. Overloading is strictly prohibited; replace the rope with a new one.
2. The hook head is skewed and cannot rotate flexibly
Cause: The thrust bearing is damaged.
Solutions and measures: Thrust bearing replacement.
Causes and prevention methods of semi-enclosed hook sets falling
The above is an introduction to the reasons for the fall of semi-enclosed hook sets and prevention methods. You can find out. If you have any questions or needs, you can contact us at any time! You can also leave your contact information directly on the website, and we will contact you in time!
There are two reasons why the semi-enclosed hook group falls:
l. The whereabouts of the hook group
Cause analysis:
①The floating limit does not work, causing the hook head to rush to the top and cause the hook group to fall;
② Sudden start of excessive inertia force under heavy load;
③Seriously overloaded or seriously damaged the wire rope.
Methods and measures for exclusion:
Immediately repair the rising limiter to make the H base work sensitively. Follow the safe operating procedures and start smoothly. Overloading is strictly prohibited; replace the rope with a new one.
2. The hook head is skewed and cannot rotate flexibly
Cause: The thrust bearing is damaged.
Solutions and measures: Thrust bearing replacement.
Causes and prevention methods of semi-enclosed hook sets falling
The above is an introduction to the reasons for the fall of semi-enclosed hook sets and prevention methods. You can find out. If you have any questions or needs, you can contact us at any time! You can also leave your contact information directly on the website, and we will contact you in time!
There are two reasons why the semi-enclosed hook group falls:
l. The whereabouts of the hook group
Cause analysis:
①The floating limit does not work, causing the hook head to rush to the top and cause the hook group to fall;
② Sudden start of excessive inertia force under heavy load;
③Seriously overloaded or seriously damaged the wire rope.
Methods and measures for exclusion:
Immediately repair the rising limiter to make the H base work sensitively. Follow the safe operating procedures and start smoothly. Overloading is strictly prohibited; replace the rope with a new one.
2. The hook head is skewed and cannot rotate flexibly
Cause: The thrust bearing is damaged.
Solutions and measures: Thrust bearing replacement.
Causes and prevention methods of semi-enclosed hook sets falling
The above is an introduction to the reasons for the fall of semi-enclosed hook sets and prevention methods. You can find out. If you have any questions or needs, you can contact us at any time! You can also leave your contact information directly on the website, and we will contact you in time!
Inquiry
Please leave us your requirements, we will contact you soon.